Restore archived tasks, fix dashboard scroll-reset, bind ornith, add Playwright smoke test

- **Restore 82 completed tasks** from tasks/complete/ back to tasks/ top
  level (all <7 days old per the cleanup policy; premature bulk archive
  was fixed).
- **Dashboard: fix scroll-reset on auto-refresh** — renderBoard rebuilds
  the board via innerHTML every 2s, destroying each column-body's
  scrollTop. Now snapshots column-body scrollTop + board.scrollLeft +
  view.scrollTop before rebuild and restores after (matched by
  PHASE_GROUPS index).
- **Dashboard UI additions** (pre-existing unstaged work): approval
  section cards, transition buttons, inline artifact editor (textarea for
  writing missing SPEC/VERDICT/etc from the detail modal).
- **Bind ornith as Implement model** — config.md: Model explicit to
  omlx/Ornith-1.0-35B-4bit-mlx, context window 32768. Interactive
  autopilot already used ornith via opencode default; now explicit.
- **Fix cleanup stub** — automaton-cleanup.sh had a stale --project arg
  pointing at a pytest temp dir (test isolation leak). Rewired to point
  at ~/.automaton.
- **Fix plist-isolation test** — test asserted host plist doesn't exist,
  but a real install creates it. Now snapshots mtime before run, asserts
  unchanged after (only a write during the test counts as bleed).
- **New Playwright smoke test** (tests/test_dashboard_ui.py) — 2 tests:
  board renders tasks, column scroll survives auto-refresh tick.
  Verified the test fails without the scroll fix (scrollTop resets to 0).
  Skipped via importorskip when playwright is absent (main CI stays
  green).
- **Clarify SI loop scope in README** — new-project onboarding section
  documents the framework-scoped self-improvement loop and options
  (leave/pause/create project loop).
- **CHANGELOG** documents all changes including the known model-divergence
  gap (mde tasks marked complete but per-role model binding was never
  implemented).

tasks/add-self-improvement-loop/BUG_REPORT.md

@@ -0,0 +1,23 @@
+# BUG_REPORT: add-self-improvement-loop
+
+## Findings
+
+### Bug 1 (LOW): install.sh loop bootstrap is inside the `else` block
+
+The loop creation commands are inside the `else` block of `if [ -d "$FRAMEWORK_DIR" ]`, which means they only run on fresh installs. If a user previously installed the framework before this change and runs `install.sh` again, they get "already installed" and the loop is NOT created. This is correct behavior -- `update.sh` handles the existing-user case.
+
+**Severity:** LOW (by design)
+**Fix:** None needed.
+
+### Bug 2 (INFO): No `--project` flag consistency check
+
+`install.sh` uses `--project "$FRAMEWORK_DIR"` while `update.sh` also uses `--project "$FRAMEWORK_DIR"`. Both are consistent. The `work_source.project` in the template is `"~/.automaton/"` (a string), but `--create-loop` doesn't use `work_source.project` -- it uses the `--project` flag. The runner reads `work_source.project` at tick time. No mismatch because `--project "$FRAMEWORK_DIR"` (which is `$HOME/.automaton`) and `work_source.project: "~/.automaton/"` resolve to the same path.
+
+**Severity:** INFO (no bug)
+**Fix:** None needed.
+
+## Summary
+
+No correctness bugs found. One LOW (by design) and one INFO.
+
+**Verdict: CLEAN**